What does the flashing or flickering flame mean?

The flashing or flickering flame indicates that the thermostat is calling for heat. Only on two stage thermostats, if you have a number 2 or two flames then the system is looking to turn on a second stage of heating to help the first stage. This would be due to the fact that the system is calling for more than three degrees or the first stage hasn't been able to raise the temperature by itself.

What does the flashing snowflake mean?

The flashing snowflake indicates that the thermostat is calling for cooling. Only on two stage thermostats, if you have a number 2 or two snowflakes then the system is looking to turn on a second stage of cooling to help the first stage. This would be due to the fact that the system is calling for more than three degrees or the first stage hasn't been able to lower the temperature by itself.

How do I use the high and low setpoints?

The high and low limits do not work when auto changeover is used, only in a standard heat or cool mode. The high limit is the highest the heat set temperature may be set to and the low limit is the lowest the air conditioning may be set to.

How can I change or turn off the filter monitor?

Press the UP and DOWN arrows simultaneously for 3 seconds and release. Press and release the FLAME/SNOWFLAKE button until you see CHECK. The filter monitor is adjustable from 0-9900 hours in 100 hour increments with the arrows. When finished press the START/STOP SCHEDULE button to exit.

How do I set the differential?

Press the up and down arrows simultaneously for 3 seconds and release. Use the flame/snowflake button to scroll down to diFF for differential. The differential is adjustable from .5-3 degrees in .5 degree increments with the arrows. Press the start/stop schedule to exit the setup.

Subscribe to RSS - RS6110 Series